CKB:Configuring Logical Volume Manager (LVM)

Aus Cryptshare Documentation
(Weitergeleitet von RESTAPI:74384670)
Wechseln zu:Navigation, Suche


Applies to:

All versions of Cryptshare Virtual Appliance

Purpose:

This is an example on configuring LVM on Cryptshare Appliances

Solution:

1. log in as root on your appliance

2. run the command yast

3. navigate to System → Partitioner and press Enter 74384686.png

4. press Enter to agree the Warning 74384688.png

5. navigate to virtual disk which will be used for LVM

74384692.png

6. add new partition as Raw Volume (unformatted) 74384695.png74384696.png

7. do not format device and select Linux LVM as Partition ID 74384698.png

8. repeat steps 5, 6 and 7 for all disks which will be used for LVM

9. navigate to Volume Management and create new Volume Group

74384699.png 10. enter the volume name, select and add previously configured disks

74384700.png74384701.png

11. create new Logical Volume on the volume group

74384702.png74384703.png74384704.png74384705.png

12. format the volume e.g. as EXT4 and add a mount point you prefer, e.g. /var/opt/data

74384706.png74384707.png74384708.png74384709.png

13. new volume will be mounted now

74384710.png

14. create needed folders on the new volume, e.g. uploads, backup and tmp and apply needed permissions

mount

cryptshare:~ # mkdir /var/opt/data/uploads
cryptshare:~ # mkdir /var/opt/data/backup
cryptshare:~ # mkdir /var/opt/data/tmp
cryptshare:~ # chown -R csuser:csgroup /var/opt/data

15. configure corresponding entries on Cryptshare Administration Interface

74384711.png74384712.png

for configuring temp folder visit this page